Demo Mode; System Checkout; Alignment - uAvionix AV-30-E Installation Manual

Rotate the center knob until "AID MODE" is displayed. If the internal
magnetometer is available (P/N UAV-1004035-002) then you will have a
choice of NONE, MAG1, and MAG2. If the internal magnetometer is not
found, only "NONE" will be displayed. If Serial 4 is set to AVMAG, AID
MODE will be automatically set to AVMAG and is not otherwise settable.
Push the center knob and rotate to select your choice of Magnetometer
aiding then push the center knob again to confirm your choice.
13.1.10

Demo Mode

Set Demo Mode to DISABLED. Demo Mode will automatically be
disabled when reaching an airspeed of 35 knots.

13.2 System Checkout

The following procedures must be performed prior to returning the
aircraft to service.
13.2.1

Alignment

During initial startup, the ALIGN annunciator should be presented as a
flashing red flag. This indicates internal sensor stabilization is occurring.
During the alignment, do not move the aircraft.
UAV-1004234-001, AV-30-E Installation Manual
Rev H
Figure 39 - AID Mode Selection
109