Mandatory Settings; Unit Function - uAvionix AV-30-E Installation Manual

Label
Checklist of systems to
exercise and monitor for
INTERFERENCE
excessive interference
with the AV-Mag
Orientation of the installed
INSTL ORIENT
AV-Mag
Angles of the AV-30
AV-30 instrument in the
stationary aircraft.
Roll angle of the AV-Mag
ROLL ANGLE as mounted in the
stationary aircraft
Pitch angle of the AV-Mag
PITCH ANGLE as mounted in the
stationary aircraft
Option to save changes to
SAVE (Y/N)
input roll and pitch angles
Final screen of installation
submenu. The next step
COMPLETE
of installation is to run the
calibration procedure.
* Initial factory value

13.1 Mandatory Settings

The following settings are mandatory for each installation.
13.1.1

Unit Function

• Set to AI if installation is replacing an existing Attitude Indicator.
• Set to DG if installation is replacing and existing Direction Indicator.
• Set to either when installed as a non-required instrument. In this
mode, this setting is the initial default operating mode if the function
lock below is not set to locked. With this setting, the pilot may toggle
the mode during flight.
UAV-1004234-001, AV-30-E Installation Manual
Rev H
Table 13-2 - AV-Mag Submenu
Description Possible Values
LIGHTS, AVIONICS, CONTROLS,
OTHER, ALL ON, REVIEW
See Table 11-5 for more details
No user entry. Information for AV-
Mag installation only. AV-Mag
should be installed as closely as
possible to the AV-30 angles.
Trim as needed: ±10 degrees
(0.0*) – May be automatically self-
measured by AV-Mag hardware
Trim as needed: ±10 degrees
(0.0*)– May be automatically self-
measured by AV-Mag hardware
YES, Y/N?, NO. Only save when
installing and a valid hand
measurement of the angles AS
THE AIRCRAFT SITS. Do not 're-
save' the values when reviewing as
this will trigger re-calculations that
will be invalid if the aircraft has
been moved since the hand
measurement.
Information only
Configured
Value(s)
104