Vibration Check - uAvionix AV-30-E Installation Manual

On the GPS navigator, set a destination waypoint and initiate a direct-to
sequence. Note that not all navigators will output serial data until a
waypoint has been selected and navigation initiated.
13.2.7

Vibration Check

Prior to flight, a vibration check must be completed. The vibration check
helps ensure the vibration characteristics of the aircraft and installation
are suitable for use. The check procedure is performed during an engine
run-up.
1. Before applying power to the AV-30, press and hold the center rotary
knob and apply power. As the splash screen appears, check that a
minimum version of 2.1.1 is displayed.
2. Enter the "Install Menu" page by pressing and releasing the left
button repeatedly until the 3
3. Rotate to "VIBE MONITOR" and press the center button.
4. The Vibration Monitor will display current and peak values for the
Accelerometer and Gyroscope.
UAV-1004234-001, AV-30-E Installation Manual
Rev H
rd
menu is displayed.
Figure 54 – Vibe Monitor Selection
120