uAvionix AV-30-E Installation Manual page 102

IAS VNO
IAS VNE
IAS VMC
IAS VYSE
BARO UNITS
TEMP UNITS
GPS NAV SRC
SERIAL 1
SERIAL 2
SERIAL 3
SERIAL 4
STATE SYNC
AID MODE
AVMAG INSTL
AVMAG CAL
AVMAG YAW
MAG MONITOR
VIBE MONITOR
GYRO CAL
INT MAG CAL
UAV-1004234-001, AV-30-E Installation Manual
Rev H
Maximum structural
cruising speed
Never exceed speed
Minimum control
airspeed with the critical
engine inoperative
Speed for best rate of
climb OEI (single engine)
Altimeter barometric
units
OAT units
Serial GPS format
GPS serial input
Auxiliary serial input
System serial input
AV-Mag serial input
Synchronization of pilot
settings across multiple
AV-30 using AV-HSI or
between an AV-30 and
EFIS.
AHRS aiding mode
AV-Mag Installation
Calibrates external
magnetometer
AV-Mag installed Yaw
angle trim
Magnetometer monitor
Vibration monitor
Calibrates aircraft gyros
Calibrates internal
magnetometer
Set to match limits: 40 to 555
(150*) in IAS UNITS
Set to match limits: 40 to 555
(175*) in IAS UNITS
Set to match limits: 40 to 555
or disabled* in IAS UNITS
Set to match limits: 40 to 555
or disabled* in IAS UNITS
Inches of Mercury* (INHG),
Millibars (MB), hectopascals
(HPA)
Celsius* (C) or Fahrenheit (F)
NONE, SERIAL 1*, SERIAL
2
NONE, AV 9600*, NMEA
4800, NMEA 9600, BCNX
GPS
NONE*, BEACON X, AV-
APA, AEROCRUZE, PRO
PILOT
NONE, AVLINK*, EFIS,
EFIS+AVLINK
NONE*, AVMAG
Source: None, AV-HSI*, EFIS
Heading Bug: No, Yes*
OBS: No, Yes*
Set Altitude: No, Yes*
Set Vertical Speed: No, Yes*
Autopilot Mode: No, Yes*
CDI Source: No, Yes*
Baro Setting: No, Yes*
OAT: No, Yes*
DG: No, Yes*
Alerts: No, Yes*
[1]
NONE , MAG1*, MAG2,
[2]
AVMAG
See Table 13-2 for submenu
description
Perform calibration after
installation – only available
for units with external
magnetometer
Trim as needed: ±15 Degrees
(0*)
Push to view
Push to view
Perform at installation or
software update
Perform calibration after
installation – only available
for units with internal
magnetometer. Disabled
Record settings in
Table 13-2
102