11.1.4
AV-Link Firmware
The firmware contained in AV-Link is identified by electronic marking.
Firmware information can be accessed via an embedded web page.
11.1.5
AV-Link Installation Materials and Tools
AV-Link installation requires access to these tools:
• Flat Screwdriver
• 3/16" Nut Driver
11.1.6
Additional Required Equipment
AV-Link is designed to interface with an existing AV-30 display. To take
advantage of AV-Link the following equipment is required:
• AV-30 3-1/8" Display
11.1.7
Mounting
AV-Link is mounted in series between the AV-30 and the AV-30 backshell
connector.
11.1.8
Removing AV-30 From Instrument Panel (Optional)
It may be necessary, because of space limitations, to remove the AV-30 unit
for performing AV-Link installation. Using a Phillips screwdriver, remove the
four [4] screws that attach the AV-30 to the aircraft instrument panel. Pull
unit down to a workable position. Note that it may also be necessary to
disconnect the Pitot and Static lines to bring into reach. Ensure that the lines
are properly labeled before disconnecting.
UAV-1004234-001, AV-30-E, Installation Manual
Rev C
32