Digital Autopilots; Digital Autopilot Control - uAvionix AV-30-E Installation Manual

11.5 Digital Autopilots

The autopilot interface supports the BendixKing AeroCruze 100/xCruze
100/TruTrak Vizion (385 and PMA) or the Trio Pro Pilot.
For complete AeroCruze installation guidance, see
Installation Guide For Vizion PMA Autopilot, Trutrak Doc: 166
and Vizion Series Autopilots Dynon SkyView Interface
Supplement 8300-087 Rev IR.
For complete Trio Pro Pilot installation guidance, see the Trio
Avionics Pro Pilot Manual for Experimental Aircraft.
Select 'AEROCRUZE' or 'PRO PILOT' in the Serial 2 installation menu.
The serial baud rate is set to match the autopilot default of 9600, N, 8, 1
and is not manually configurable.
11.5.1

Digital Autopilot Control

See "Operating Handbook for Vizion PMA Autopilot TruTrak Doc:167"
for detailed operation of the AeroCruze/TruTrak autopilot.
See "Trio Avionics Pro Pilot Manual for Experimental Aircraft" for
detailed operation of the Trio Pro Pilot autopilot.
• Power on the autopilot and sync the altimeter on the autopilot
• Leave the autopilot disengaged until the AV-30 is powered on and
operational.
See AV-30-E Pilot's Guide UAV-1004233-001 for detailed operation of
the autopilot control interface.
To provide the most accurate heading information for autopilot heading
hold mode, it is strongly recommended that the AV-MAG be used in
conjunction with the digital autopilot.
UAV-1004234-001, AV-30-E Installation Manual
Rev H
79