uAvionix AV-30-E Installation Manual page 111

3. It is critical to ensure the aircraft is completely motionless and on the
ground during the next several steps. The aircraft should be in a
hangar and must not be affected by wind or other sources of aircraft
movement. Do not leave the aircraft during the countdown.
4. Enter the "Install Menu" again. Rotate to Gyro Cal and push the
center button to choose calibration. If sufficient warmup time has not
elapsed, a "Not ready to calibrate" message and countdown will be
indicated. Otherwise, initiate calibration by pressing the right button.
5. "Calibration in progress" will be displayed with a completion
percentage.
UAV-1004234-001, AV-30-E Installation Manual
Rev H
Figure 41 - Install Mode Selection
Figure 42 - Gyro Calibration Selection
111