uAvionix AV-30-E Installation Manual page 107

NMEA 9600
BCNX GPS
AV-HSI
SERIAL 2
This serial port corresponds to DB-15 pins 4 and 5. This serial port
supports a tailBeaconX or autopilot connection.
If using the AV-30 as a control head for a tailBeaconX, set SERIAL 2 to
BEACON X. Otherwise, set SERIAL 2 according to the autopilot
connection (or NONE if nothing is connected).
Value
NONE
BEACON X
AV-APA
AEROCRUZE
PRO PILOT
SERIAL 3
Serial 3 is the system serial port. If using the AV-Link, set SERIAL 3 to
AVLINK to enable MFD page. If connecting to a third-party EFIS, set to
EFIS. If using an AV-Link and connecting a third-party EFIS, set to
EFIS+AVLINK.
Value
NONE
AVLINK
EFIS
UAV-1004234-001, AV-30-E Installation Manual
Rev H
NMEA format (9600 bps)
tailBeaconX is installed (see Figure 21)
ARINC-429 navigator connected to AV-
HSI
Serial 3 Source
None available
AV-Link is installed, MFD enabled
Third-party EFIS connected
Serial 2 Source
None available
tailBeaconX is installed on
SERIAL 2
AV-APA is installed on SERIAL 2
AeroCruze 100/ xCruze 100
/TruTrak Vizion autopilot
Trio Pro Pilot
107