Av-Apa Installation Overview; Av-Apa Installation Materials And Tools - uAvionix AV-30-E Installation Manual

11.4.3

AV-APA Installation Overview

An overview of the installation process is provided below. Further detail
for the process may be found later in this document.
1. Configure the AV-30-E.
a. In the AV-30-E installation menu, set SERIAL 2 to AV-APA
to enable AV-APA functionality in the AV-30-E.
b. In the AV-30-E installation menu, set the appropriate
autopilot type under the 'AV-APA CFG' option.
c. If using the serial pass-through capability of the AV-APA,
select the connected device in the 'AV-APA THRU' option.
2. Wire and mount the AV-APA
a. Identify the mounting location.
b. Wire the AV-APA to the AV-30-E and autopilot as described
below. Detailed information about your autopilot can be
found in your autopilot's installation manual.
c. Mount the AV-APA using appropriate fasteners. Fastener
length and type will vary by installation and are therefore not
provided in the installation kit. Use AC 43.13-1B for
guidance.
3. Perform a ground checkout.
a. Perform a ground checkout as described below and as
described in your autopilot installation manual.
Record your work in the aircraft log book.
11.4.4

AV-APA Installation Materials and Tools

AV-APA installation kit includes the following components:
• One 9-pin D-Sub socket connector and shell
UAV-1004234-001, AV-30-E Installation Manual
Rev H
• The AV-APA should be mounted to something rigid in
a location that does not interfere with flight control
movement.
• The AV-APA is not waterproof; it must be mounted in a
dry location.
73