Display Units; Serial Inputs; Demo Mode; System Checkout - uAvionix AV-30-S Installation Manual

10.5.5 Display Units

10.5.6 Serial Inputs

10.5.7 Demo Mode

10.6 System Checkout

10.6.1 Alignment

UAV-1003947-001, AV-30-C, Installation Manual
Set the IAS units to match that of the existing airspeed indicator.
Set the Baro units to match that of the existing altimeter.
Set OAT units to owner / pilot preference.
Set GPS Nav Source to the corresponding GPS navigator input
type. Most handhelds are NMEA outputs while most panel
mounted navigators are Aviation format. If no GPS is
connected, set to NONE.
Set Serial 2 to NONE.
Set Demo Mode to DISABLED
During initial startup, the ALIGN flag should be presented and
flash. This indicates internal sensor stabilization is occurring.
This should extinguish within 3 minutes, at which point valid
attitude or direction indication is displayed.
If this is not observed, reference the trouble shooting section of
this document for additional information.
Figure 17 - Align Flag
34 Revision C