Dip Switches (For Smd 19102 Only); Connecting The Power Cable - Eizo SCD 19102 Instructions For Use Manual

BNC socket (video input)
• Connect video cable for the composite input to the BNC socket.
See also
Connection panel
5.6

DIP switches (for SMD 19102 only)

The SMD 19102 has two DIP switches between the three BNC sockets.
These switches are used for changeover between high impedance (10 kΩ) and low impe‐
dance (75 Ω) for the H and V synchronization inputs.
Fig. 6: Position of the DIP switches
Delivery state
Switch
SW1
SW2
5.7

Connecting the power cable

CAUTION
Only connect the device to line power with a protective conductor
• To avoid risk of electric shock, this device must only be connected to line power with a
protective conductor
• Contact the responsible building technician or a qualified electrician if you are uncertain
whether the line power is equipped with a protective conductor.
The power cable socket is located on the back of the monitor. The monitor's power supply is
connected using an appliance plug.
• Open and close the connection panel using an appropriate tool.
• Insert the appliance plug of the supplied power cable into the line power socket.
• The power cable can be secured using a cable grip.
SCD 19102 / SMD 19102
Instruction for Use, 05/2013
[} 19]
Function
Input resistance for H/H+V signal
Input resistance for V signal
5.6 DIP switches (for SMD 19102 only)
Delivery state
75 Ω
75 Ω
Connecting
21