Eizo SCD 19102 Instructions For Use Manual page 64

Start-up
6.4 System settings
2. If you reach the limit of the control range when setting, you must perform the "Force"
command with the selection "For static pictures" or "For motion pictures". The current
setting is then saved, and the slider set to the center of the control range. Once you
have set the signal frequency optimally, you can continue with the adjustment.
Note: For progressive timings with an image refresh rate greater than 60 Hz, only the
items "For static pictures" or "Reset" can be selected in line 6 in the "Live mode" menu.
64
SCD 19102 / SMD 19102
Instruction for Use, 05/2013