System Settings; Avoiding Image Sticking; Setting The Image Geometry; Setting Brightness And Contrast - Eizo SCD 19102 Instructions For Use Manual

Start-up

6.4 System settings

• Press key "4" and then key "2" three times.
The OSD menu is locked.
Unlock
• Press key "4" once and then key "2" three times (if the OSD is not active).
The OSD menu is unlocked.
Delivery state
The OSD is unlocked.
6.4 System settings
Note
Optimum picture quality
To achieve optimum picture quality, the monitor must be operated with a graphics resolu‐
tion of 1280 x 1024 pixels. The corresponding setting for the graphics card must be made
in the operating system.
6.4.1

Avoiding image sticking

Image sticking may occur with TFT monitors. It is an effect where a faint image of the previ‐
ous screen contents can be seen after the display contents have changed. The following
measures can reduce or prevent image sticking:
• Use a screen saver with regularly changing images
• Switch off the monitor when it is no longer needed.
• The monitor has an energy saving mode:
If the application in use supports the energy saving mode, activate it.
6.4.2

Setting the image geometry

The monitor automatically recognizes the standard used, and has preprogrammed set-up
values for each standard. However, depending on the graphics card used, it may still be
necessary to align and size the picture for the selected standard.
6.4.3

Setting brightness and contrast

The brightness and contrast must be adjusted for the respective graphics card in the system
on site due to different output levels.
CAUTION
The exact brightness and contrast settings are possible only with a photometer.
54
SCD 19102 / SMD 19102
Instruction for Use, 05/2013