Connecting The Signal Cable - Eizo SCD 19102 Instructions For Use Manual

Connecting

5.5 Connecting the signal cable

5.5 Connecting the signal cable
Note
• The video signals coming from a graphics card are referred to in the following as RGB
signals, and those coming from a camera, DVD player, video recorder etc. as video sig‐
nals.
In the OSD menu, some of the menu displays are also identified by RGB or video ac‐
cordingly in the header.
• At least one signal source must be connected in order to activate the OSD.
• All signal inputs may be connected simultaneously.
• The Up and Down keys can be used to select which RGB or video source is to be dis‐
played when the OSD is not active. Selection is also possible in the OSD.
CAUTION
• When connecting to the BNC sockets, the three cables for the R, G and B signals must
be of equal length. Otherwise, color fringing, which appears similar to convergence
faults, will occur due to unequal propagation times.
• The levels of the incoming analog RGB signals must be equal.
• If the same RGB signal is connected to several monitors via the BNC sockets using T-
connectors, the R, G, B, and H DIP switches on the monitors must be set to 10 kΩ.
These DIP switches must be set to 75 Ω on the last monitor in the chain.
The signal cable connections are located on the back of the monitor.
15-pin Sub-D socket
• Connect VGA cable with the 15-pin Sub-D connector (male) for the analog input to the
15-pin Sub-D connector (female).
DVI socket
The DVI cable can be connected in two ways:
• With DVI digital signal or
• With DVI analog signal (SCD 19102 only)
BNC sockets (SoG / H / V)
With a wire (R or G or B, with composite synchronization):
•
– Connecting wire for BNC connection "G".
• With three wires (R or G or B, with separate synchronization):
– Connecting wire for BNC connections "G", "H/H+V" and "V".
4-pin mini-DIN socket (video input)
• Connect video cable for the sync video input (Y/C signal) to the 4-pin mini-DIN socket.
20
SCD 19102 / SMD 19102
Instruction for Use, 05/2013