Eizo SCD 19102 Instructions For Use Manual page 63

Note: If the "Reset" setting is selected, all learned values are deactivated in the current
Force Mode window.
Optimize scanning frequency
The correct signal frequency must now be set ("Horizontal lines. (total)").
1. In order to set "Horizontal lines (total)" correctly, it is best to use an SMPTE and a pixel
on/pixel off test pattern. If the test patterns are not available, you can use an image with
clearly defined border and a line written "lllllll" for the setting. Optimize the signal fre‐
quency such that no interferences are present in the picture. If the interval between the
interferences becomes larger, and these therefore also become fewer, you are moving
the slider in the correct direction.
SCD 19102 / SMD 19102
Instruction for Use, 05/2013
Start-up
6.4 System settings
63