Table of Contents
Advertisement
2. CABLE CONNECTION
2-1. Before Connecting
Before connecting your monitor to the PC, change the display screen settings
accordance with the
When your computer and display support VESA DDC, the suitable resolution and the refresh rate are
set by just plugging your display into the computer without any manual settings.
2-2. Connecting the Signal Cable
Be sure that the power switches of both the PC and the monitor are OFF.
1. Plug the signal cable into the connector at the rear of the monitor and the other end of
the cable into the video connector on the PC.
After connecting, secure the connection with the screw-in fasteners.
Analog Input
Signal Cable
Signal Cable
(FD-C16 enclosed)
Digital Input
Signal Cable
APPENDIX
charts.
Connector of the PC
Video Output
Connector / D-Sub mini 15 pin
Input Connector
(monitor) / DVI
Connector of the PC
(Resolution
PC
Standard graphics card
Power Macintosh G3 (Blue & White) / Power
Mac G4 (VGA)
PC
and frequency) in
Advertisement
Table of Contents
