Using The [Console] Port - Icom IP1100CV Installation Manual

4
FOr yOUr iNFOrmATiON
Accessing with Telnet/SSH

■ Using the [CONSOLE] port

you can control the Controller using the terminal software by connecting the [CONSOLE] port of the Controller
to a USB port of the PC through a USB (Type-C) cable (user supplied).
The USB driver for the icom network devices is required.
Download the USB driver and the manual from the icom web site and install it according to the manual.
https://www.icomjapan.com/support/
After installing the USB driver, set the serial port settings in the terminal software as follows:
• Port: Check the COm port number setting on your PC
• Baud rate: 115200 bps
• Data: 8 bit
• Parity: None
• Stop: 1 bit
• Flow control: None
When the COM port setting is finished, press the [Enter] key to display the "IP1100CV login:" prompt.
4-5