Individual Call - Icom IP1100CV Installation Manual

1
BeFORe uSING The CONTROLLeR
Feature description

■ Individual Call

Individual Calls are used to talk to a transceiver 1 on 1.
When an Individual call is made, the WLAN transceiver displays the connection status. (Connected, Busy, or
No response)
L If the destination that you are calling is out of range, "No response" is displayed.
L Set the Receive Notification Tone on the [Profile] screen to notify a connection status, if necessary.
(Transceiver Controller > Common Settings > Profile)
IP110h
Sales 1
■ Calling mode
When you are receiving or transmitting, the transceiver enters the calling mode.
While in the calling mode (until the Talkback Timer elapses,) you can communicate to the destination only with
the transmitting operation.
About TalkBack Timer
The TalkBack timer starts when the calling transceiver finishes transmitting until the transceiver returns to the
standby mode. (Default: 5 seconds)
About the communication priority while in the TalkBack Timer
If a new call has arrived while in the TalkBack Timer, it is accepted according to the call priority.
The transceiver accepts incoming calls with a higher priority than the current call, but not lower or equal
priority. The incoming call will be accepted after the TalkBack Timer has elapsed.
The Talkback Timer set in the Controller is shared in each setting group to that the WLAN transceiver belongs.
Wireless
access point
IP110h
Sales 1
Regular Individual Call
destination: Sales 3
IP1100CV
Individual call
IP1100CV
Sales 3
Sales 2
Wireless access point
Sales 2
Sales 1
Individual Call from
Sales 1 to Sales 2
has arrived
1-10
Selecting an Individual Call
(example: Sales 1 calling Sales 2)
Displays the
connection status
enters Calling
mode
Sales 2
The destination changes from
Sales 3 to Sales 1
Sales 3