Installation Overview - Icom IP1100CV Installation Manual

2
SETTING uP ThE SySTEM

Installation overview

The following shows a typical setting procedure for the WLAN transceiver controller on the IP1100CV Setting
screen.
1
Network Settings > IP Address
Enter the IP address according to your network environment. (Default: 192.168.0.1)
Network Settings > DHCP Server
Enable or disable the Controller's DhCP server function. (Default: Disable)
2
Transceiver Controller > Transceiver settings > Transceiver Registration
Transceiver Controller > Common Settings
Enter the Transceiver Model, Name and unit ID, Password and Setting group.
L The default password is "iptrx". you can change it for security.
L Customize the common settings for the transceiver group (Tenant) on the Common Settings screen.
Setting by the CS-IP100H
After WLAN transceivers are registered to the Controller, set the wireless LAN settings and provisioning
server settings (Controller) for all the transceivers.
L The CS-IP100h
website. Refer to each manual for details.
3
Transceiver Controller > Transceiver settings > Transceiver settings
Set the functions, such as Communication Method (Simplex or Full-Duplex), Priority Call, Area Call,
Message, and Status, for each transceiver.
Enable the required functions for all the WLAN transceivers that are registered on the Transceiver
Registration screen.
• use ID list
• Priority Call
• Message
4
Destination Settings > Destination Settings
Assign the registered WLAN transceivers or IP100FS on the Transceiver Registration screen to a group.
The group ID and the communication type are set on the Destination Settings screen.
NOTE: Applying the settings to the WLAN transceiver
If the Controller's setup has been changed, be sure to restart the transceiver to apply the setting.
cloning software
and CS-IP110h
cloning software
• Communication Method (Simplex/Full-Duplex)
• Area Call
• Status
or the CS-IP110H
programming software
programming software
2-2
can be downloaded from the Icom
(☞ Continued on the next page)