Table of Contents
Advertisement
2
SETTING uP ThE SySTEM
Configuring the WLAN transceiver system
Transceiver Controller > Common Settings > Status
■ The Status
Enter a status that the WLAN transceiver will transmit.
L Set "Status" to "Enable" to use the status.
(Transceiver Controller > Transceiver Settings > Transceiver Settings > Transceiver Settings)
L After completing the settings on this screen, restart the transceiver to apply them.
1
Open the Status screen.
(Transceiver Controller > Common Settings > Status)
2
Enter status message of up to 32 characters, and then click <Apply>.
L up to 10 status messages can be entered.
L uncheck the box on the left of the status message, if you do not want to display it on the transceiver.
2-12
1 Enter
2 Click
Advertisement
Chapters
Table of Contents
