Updating The Firmware From A Usb Flash Drive - Icom IP1100CV Installation Manual

3
MAINTENANCE

Updating the firmware from a USB flash drive

You can update the Controller firmware by using a USB flash drive (user supplied).
Download the firmware and save it onto the USB flash drive as follows, and then update the Controller.
Also, refer to the "Automatic Restoring from a USB flash drive" and "Updating the firmware" former in this
section.
1
Download and extract the IP1100CV firmware from the Icom web site.
2
Save the firmware data onto the USB flash drive, with the file name "firmware.dat."
L If there is a specific folder of the IP1100CV, save the firmware into the folder.
L The IP1100CV cannot read the firmware from the other file than "firmware.dat."
3
Select a IP1100CV to update the firmware.
4
Insert the USB flash drive into the USB port of the IP1100CV.
• The [USB] indicator lights green when the USB flash drive is successfully
mounted.
5
Push the <USB EJECT> button.
• The Controller reboots to update the firmware.
6
Confirm the [POWER] indicator lights green, and hold
down the <USB EJECT> button until the [USB] indicator
turns OFF.
Confirm the [USB] indicator turns OFF, and then
remove the USB flash drive from the Controller.
7
Confirm the Controller firmware version has been updated on the setting screen.
(TOP > System Status)
CAUTION:
• DO NOT remove the USB flash drive or turn OFF the Controller until the firmware is completely updated.
Otherwise the settings data or the Controller may be damaged.
• DO NOT access the IP1100CV Setting screen until it is completely rebooted.
• Before removing the USB flash drive, confirm the [USB] indicator is not lit.
Confirm [USB]
w
has turned OFF
Remove the
e
USB flash drive
3-15
[USB] Port
Push <USB EJECT>
Hold down
q
<USB EJECT>