Table of Contents
Advertisement
3
MAINTENANCE
Updating the firmware
Management > Firmware Update
■ Manual update
Before updating the firmware, save the current setting into a file.
NOTE: Some settings may be returned to their defaults after the firmware update. Refer to the Icom website for details.
TIP: In order to protect the Controller from maintenance by unknown users, Icom recommends restricting
access to the setting screen during normal use.
1
Open the Firmware Update screen.
(Management > Firmware Update)
2
In [Manual Update], click <Choose file...>, and then select a firmware file (extension: "dat").
• The selected file name is displayed in the "Select the update file" item.
3
After the update is complete, click [Back].
• Returns to the setting screen.
If the setting screen is not displayed, the update may not be completed. Wait for a few minutes, and then click
[Back] again.
CAUTION: DO NOT turn OFF the Controller and the PC while updating the firmware. It will cause data
corruption, or damage.
If you cannot access the Controller setting screen after the updating, the IP address of the Controller may be
reset to the default (192.168.0.1).
Set your PC's IP address to the same network domain (for example: 192.168.0.100) and access the
Controller. After changing the Controller's address properly, return the PC's address according to your
network environment.
Select the firmware file (extension: dat)
3-7
q Click
w Click
Click
Advertisement
Chapters
Table of Contents
