Configuring The Wlan Transceiver System; Connecting To Wlan Transceivers - Icom IP1100CV Installation Manual

2
SETTING uP ThE SySTEM

Configuring the WLAN transceiver system

■ Connecting to WLAN transceivers

up to 300 of the total IP100h, IP110h, and IP100FS can register to the Controller.
The following illustration is an example of setting requirements to register an IP110h to a Controller.
• Each terminal requires that you set the unit ID and so on.
• Connect a wireless access point to the Controller network.
• In this manual, it is assumed that the IP address of PCs using WLAN transceiver or IP100FS is automatically
obtained from the DhCP server in the same network as the Controller.
• When assigning static IP addresses to the terminals, make sure that the addresses of the devices on the
network don't overlap or conflict.
IP1100CV
192.168.0.1
IP110H
Sales1
Sales2 Sales3
00101
00102 00103
Sales 01
00005
Meeting
Wireless access point
Example: AP-95M
192.168.0.50
IP100H
IP100FS
00050
Sales4
(Remote communicator)
00104
Full-Duplex
operation
2-4
Sales group