Memory Scan - Icom IC-RSOOCOL Instruction Manual

51
9 scANNING
9-5 MEMORY SCAN
(1) SETTING THE MEMORY
SCAN RANGE
FM MID
BANK
845.000.00 seou
[SCAN CONDITION)
) MEMO SCAN
BANK S M1 500ch!
M2 599ch
SEL-No, #1
SEL-MODE FM
TS 25.Oknz
(12:00)
with MAIN DIAL
2) PROG SCAN
MODE= USB TS= 10
OP1 = =—=-_-2,000,00 MHz
OP2 26.000.00 MHz
[2 2F SCAN ]
Center F + 2.5kHz
3) PRIO SCAN ]
BANK 5 P= S00ch
MEMORY SCAN CONDITION SCREEN
(2) SCAN OPERATION
Ga
[MEMO]
6845.000.00 ssou
HENOSCA Bank 5
EDGE M1 500 ch
M2 599 ch
TS 25,0 kuz
While operating memory scan.
Memory scan repeatedly scans memory channels in a user-
Programmed scanning range. The scanning range can be
programmed for each memory bank ("BANK") or for
ignoring the memory bank (""NO-BANK"),
1) Access the scan condition screen:
- Push [F-1] when the menu 1 screen is selected.
2) Push [F-5] "SET 1" or "SET 3" until it becomes "SET
a
The memory scan condition screen as shown in the
diagram at left is selected.
3) Push [F-1] "BANK" to select the memory scan range in
"BANK" or '"NO-BANK.""
The memory scan bank can also be selected in the bank
status screen.
4) Select the desired memory bank (100-unit channel
number) using the [MEMORY BANK] switches, [DOWN]
or [UP] when "BANK is selected in step 3.
When "NO-BANK"' is selected, skip to step 5.
5) Push and hold [F-2] "M 1" then rotate the main dial to
set a memory scan edge,
6) Push and hold [F-3] "M 2' then rotate the main dial to
set the other side memory scan edge,
7) Push [F-6] "MENU" to return to the menu 1 screen,
1) Set the memory scan range. See (1) SETTING THE
MEMORY SCAN RANGE above.
2) Select the desired resume condition. See p. 46 Section
9-1 (3) SCAN RESUME CONDITION.
3) Adjust the [SQUELCH] control to the threshold point.
4) Push [MEMO] in the [SCAN] switches to start memory
scan.
# At least 2memory channels must be programmed in the
selected memory scan range for scanning to operate.
5) Adjust the [SPEED] control to the desired scanning
speed.
6) To stop scanning, push a [SCAN] switch ([PRIO],
[PROG], etc.) or a CRT function switch ({F-1]~[F-6] ).
© The main dial also stops scanning.