Full/Band/Programmed Scan; Memory (Bank) Scan - Icom IC-R2 Instruction Manual

6
SCAN OPERATION

Full/band/programmed scan

q Select VFO mode with [V/M].
w Make sure the squelch is set to the threshold point.
• Select automatic squelch (AUTO) or a level (1–9) where the
noise is just muted. (p. 10)
e Select the desired scan range, if desired.
Select scan edges in scan edge set mode:
"ALL" for full scan, "BAND" for band scan or "PROG 0"–
"PROG24" for programmed scan. (see the next page)
r Push [FUNC] + [Y] or [Z] momentarily to start the scan.
• Decimal point flashes while scanning.
• "P SKIP" flashes when the frequency skip function is turned ON.
(p. 19)
• "0P"–"24P" flash to indicate which pair of scan edges is being
scanned.
• To change the scanning direction, rotate [DIAL].
• If the pocket beep function is activated, the receiver automatically
selects the tone squelch function when a scan starts.
t To stop the scan, push [FUNC] + [Y] or [Z] again.
If the same frequencies are programmed into a pair of
scan edges, programmed scan does not start.
For programmed scan, scan edges must be programmed
in advance. Program scan edges in the same manner of
programming a memory channel and select a scan edge.
(p. 17)
16

Memory (bank) scan

q Select memory mode with [V/M].
w Make sure the squelch is set to the threshold point.
• Select automatic squelch (AUTO) or a level (1–9) where the
noise is just muted. (p. 10)
e Turn the memory bank scan ON or OFF in the memory
scan set mode, if desired.
• See below for details.
r Push [FUNC] + [Y] or [Z] momentarily to start the memory
(bank) scan.
• Decimal point flashes while scanning.
• To change the scanning direction, rotate [DIAL].
• If the pocket beep function is activated, the receiver automatically
selects the tone squelch function when a scan starts.
t To stop the scan, push [FUNC] + [Y] or [Z] again.
D Memory bank selection
q Select memory mode with [V/M].
w While pushing [FUNC], push [BAND] to enter memory
scan set mode.
e Rotate [DIAL] to select the memory bank scan ON or OFF.
• "ALL" indicates all memory banks are
scanned (memory bank scan OFF);
"BANK" indicates memory bank scan
is turned ON.
r Push [BAND] to exit memory scan
set mode.
Bank scan ON