Icom IC-RSOOCOL Instruction Manual page 35

6-1 INITIAL SETTINGS
SWITCH AND CONTROL SETTING
OO case oo
BASIC OPERATION 6
NOTE: Follow all instructions in Section 4 before
operating the receiver.
1) Be sure the [POWER] switch is in the out position, then
connect the AC cable into a domestic AC power outlet.
2) Be sure antennas are securely connected to the proper
antenna connectors.
3 antennas are necessary for all band coverage.
3) Be sure the receiver is grounded through the [GND]
terminal,
4) Push the [POWER] switch IN to turn ON power,
5) Set switches and controls as shown in the table below,
[swiren[posirion | switcn _[Posiriow
rower [IN _|aTT 1008 [orr
[timer our arr 2048 [or
fweren [our __|oispiay __|orr |
[Ne OFF | ANTENNA ore]
—_—
CALIBRATOR | OUT
REC SPEECH
IF SHIFT
SCAN SPEED CENTER NOTCH
AF GAIN
SQUELCH
NB LEVEL
32