Selected Memory Number; Memory Note - Icom IC-RSOOCOL Instruction Manual

8-3 SELECTED MEMORY NUMBER
™ WIDE -" BANK
947.057.00 e595u
TS 12.Skhz
az00)
Mch FREQUENCY MODE TS SEL NOTE
MEMORY LIST SCREEN
MSELECT NUMBER ALL CLEAR
Mch FREQUENCY MODE TS SEL NOTE
294 =
ol 947,057.00 FM W 12.5 #1
While pushing [F-4] "SEL."
8-4 MEMORY NOTE
FM MID
347.057.00
Mch FREQUENCY MODE
MEMORY NOTE WRITE SCREEN
MEMORY CHANNELS 8
Selected memory numbers are used for the selected number
memory scan described on p, 53, Scanning operates only
on channels programmed with the same number. 9 selected
memory numbers are available for scanning group separation.
1) Access the memory list screen.
- Push [F-2] "MEMO' when the menu 1 screen is
displayed.
2) Select the memory channel to program the selected
memory number:
- Use [F-1] "ROLL" or [F-2] "SET" with the main dial.
3) Push [F-4] "SEL" to program the selected memory
number.
To change the number, push and hold [F-4] "SEL"
then rotate the main dial. :
©The programmed scan edge channels (1P1 ~ 9P2) do
not accept writing.
4) To erase the number, push [F-4] "SEL" again.
The same selected memory numbers can be erased
simultaneously in the memory list screen.
1) Set the memory bank: "BANK" or "NO-BANK" (p. 40).
e"NO-BANK" : Erased in all memory channels.
°BANK" : Erased in the selected bank only.
2) Push and hold [F-4] "SEL" then rotate the main dial to
select the desired number to be erased.
3) Push and hold [F-4] 'SEL" then [F-3] "A CLR" until
the receiver emits 3 beeps.
8 characters of the note can be written in each memory
channel for your reference.
1) Access the memory list screen:
- Push [F-2] "MEMO" when the menu 1 screen is dis-
played.
2) Select the memory channel to write a memory note:
- Use [F-1] "ROLL," or [F-2] "SET" with the main dial.
3) Push [F-5] "NOTE" to access the memory note write
screen.
4) Choose a character with the main dial.
5) Push [F-1] "ENT" to write the character.
6) Repeat steps 4 and 5 to write your desired note.
When wrong characters are written, pushing [F-5) "CE"
clears all input then returns the screen to the memory
list screen.
7) Use "——>," "<——" and "SPACE" to move the cursor.
8) Push [F-6] "SET" to store the note.
© The screen returns to the memory list screen.
42