Selected Number Memory - Icom IC-RSOOCOL Instruction Manual

a
(1) SELECTING A MEMORY SCAN
NUMBER
FM MID #1 BANK
9347.057.50 ssaca
TS 12.5kuHz
[SCAN CONDITION] [with MAIN DIAL
2) PROG SCAN
MODE= USB TS= 10
Opt 2.000.00 MHz
OP2 26.000.00 MHz
BANK S M1 S00ch) / 3) 4F SCAN j
M2 599ch Center F + 2.SkHz
[22 PRIO SCAN ]
BANK 5 P= S00ch
MEMORY SCAN CONDITION SCREEN
(While pushing [F-4] "SEL-N.")
(2) SCAN OPERATION
(1) Push the scan number.
@® Push [SEL].
FM MID *A BANK
9$47.057.50 ssau
(SEL-M SCAN) BANK 5
SEL No.= #1
TS 12.5kt2
While operating selected number memory scan.
Q scANNING
9-7 SELECTED NUMBER Selected number memory scan repeatedly scans memory
channels with the same programmed number. Scanning
MEMORY SCAN occurs in a bank or in all memory channels that can be
ch2 ch3 ch4 selected by the memory scan bank.
To program a scan number into memory channels, see
p. 42 Section 8 - 3 SELECTED MEMORY NUMBER,
Using the memory scan condition screen, select the number
of the group to be scanned in selected number memory
scan. The selected number can also be selected by pushing
a digit key before starting or during scanning.
1) Access a scan condition screen:
- Push [F-1] "SCAN' when the menu 1 screen is dis-
played,
2) Push [F-5] "SET 1" or "SET 3" until it becomes "SET
2"
The memory scan condition screen as shown in the
diagram at left is selected.
3) Push and hold [F-4] "'SEL-N" then rotate the main dial
to select the selected number.
4) Push [F-6] "MENU" to return to the menu 1 screen.
1) Set the memory scan bank. See p. 51 Section 9-5 (1)
SETTING THE MEMORY SCAN RANGE steps 1~4.
Memory scan edges do not function in selected mode
memory scan.
2) Select the desired resume condition, See p. 46 Section
9-1 (3) SCAN RESUME CONDITION.
3) Adjust the [SQUELCH] control to the threshold point.
4) Push a digit key to select the desired scan number to be
scanned.
5) Push the [SEL] switch to start selected number memory
scan.
e@At least 2 memory channels with the same selected
number must be programmed to operate scanning.
6) Adjust the [SPEED] contro! to the desired scanning
speed.
7) To stop scanning, push a [SCAN] switch ([PRIO],
[PROG], etc.) or a CRT function switch ([F-1] ~[F-6]).
e The main dial also stops scanning.