I Memory/Bank/All Bank Scan - Icom IC-R5 Instruction Manual

I Memory/bank/all bank scan

q Select memory mode with [V/M•S.MW•~].
• Select the desired bank with [BAND•
w Set the squelch to the point where noise is just muted.
e Push [MODE•SCAN] for 1 sec. to;
• When memory mode is selected at the step
- start memory scan.
• When a bank channel is selected at the step q q :
- enter scan type selection mode.
r Rotate [DIAL] to select the desired scanning type.
• "ALL" for all bank scan; "BANK" for bank scan.
[DIAL]
[MODE•SCAN]
] for bank scan.
q q :
• All bank scan selection
• Bank scan selection
tPush [MODE•SCAN] momentarily to start all bank or bank
scan.
• Scan pauses when a signal is received.
• Rotate [DIAL] to change the scanning direction, or resumes
manually.
y To stop the scan, push [MODE•SCAN].
• During memory/all bank scan • During bank scan
W FM AM DUP SQL T DTCS
IMPORTANT!: To perform memory or bank scan, 2 or
more memory/bank channels MUST be programmed, oth-
erwise the scan never starts.
SCAN OPERATION
W FM AM DUP SQL T DTCS
6
6
28