Priority Scan - Icom IC-RSOOCOL Instruction Manual

49
9 scANNING
9-3 PRIORITY SCAN
C3 Priority channel
(1) SETTING A PRIORITY CHANNEL
™™ MID BANK
195.000.00 os7c
TS 20.0knz
580 845,000.00 FM M 25.0
(22:00)
[SCAN CONDITION) with MAIN DIAL)
2) PROG SCAN
MODE= USB TS= i0
opi 2.000.00 MHz
1) MEMO SCAN OP2 26.000.00 MHz
BANK O Mi Oech) [) aF SCAN ]
M2 © 99ch Center F + 2.SkHz
. &
(Ge) GE) [ank] [Pec [Sera] [ren]
AF/PRIORITY SCAN CONDITION SCREEN
(While pushing [F-4] "PR-CH.")
(2) PRIORITY SCAN OPERATION
[PRIO]
FM MID. BANK
1945.000.00 o57c
NO-BANK
PRIO CH = 580 ch
TS 20.0kn:
While operating priority scan.
Priority scan watches a particular memory channel during
operation. Priority channels can be set for one channel on
each memory bank or for one channel that ignores the
memory bank.
1) Access the scan condition screen:
- Push [F-1] "SCAN" when the menu 1 screen is dis-
played.
2) Push [F-5] "SET 2" or "SET 3" until it becomes "SET
1"
The AF/priority scan condition screen as shown in the
diagram at left is selected,
3) Push [F-3] "BANK" to select the priority channel in the
"BANK" or "NO-BANK" status.
The priority bank can also be selected in the bank
status screen.
4) Push and hold [F-4] "PR-CH" then rotate the main dial
to select the desired memory channel as a priority
channel.
5) Push [F-6] "MENU" to return to the menu 1 screen.
1) Set the priority channel. See (1) SETTING A PRIO-
RITY CHANNEL above.
2) Select the desired resume condition. See p. 46 Section
9-1 (3) SCAN RESUME CONDITION.
3) Adjust the [SQUELCH] control to the threshold point.
4) Push the [PRIO] switch to start priority scan.
elf the operating channel equals the priority channel,
priority scan deactivates.
5) Adjust the [SPEED] control to the desired scanning
speed.