Design And Installation Safety - Epson C Series Manual

C8 Manipulator 1. Safety

1.2 Design and Installation Safety

This product is intended for transporting and assembling parts in a safely isolated area.
Design and installation of robot system shall be performed by personnel who has taken robot
system training held by us and suppliers.
To ensure safety, a safeguard must be installed for the robot system. For details on the
safeguard, refer to the Installation and Design Precautions in the Safety chapter of the
EPSON RC+ User's Guide.
The following items are safety precautions for design personnel:
■ Personnel who design and/or construct the robot system with this product must
read "Safety Manual". Designing and/or constructing the robot system without
understanding the safety requirements is extremely hazardous, and may result in
serious bodily injury and/or severe equipment damage to the robot system.
■ The Manipulator and the Controller must be used within the environmental
conditions described in their respective manuals.
designed and manufactured strictly for use in a normal indoor environment.
Using the product in an environment that exceeds the specified environmental
conditions may not only shorten the life of the product but may also cause serious
safety problems.
■ The robot system must be used within the installation requirements described in
WARNING
the manuals. Using the robot system outside of the installation requirements
may not only shorten the life of the product but also cause serious safety
problems.
■ When designing or installing a robot system, wear at least the following protective
gear. Working without protective gear may cause serious safety problems.
Further precautions for installation are described in "3. Environment and Installation".
Please read this chapter carefully to understand safe installation procedures before installing
the robots and robotic equipment.
84
Work clothes suitable for work
Helmet
Safety shoes
This product has been
C series Rev.2