Design And Installation Safety; Relevant Manuals - Epson LS-B Series Safety And Installation

1. Safety

1.2 Design and Installation Safety

Only trained personnel should design and install the robot system.
personnel are defined as those who have taken robot system training held by the
manufacturer, dealer, or local representative company, or those who understand the
manuals thoroughly and have the same knowledge and skill level as those who
have completed the training courses.
To ensure safety, a safeguard must be installed for the robot system. For details
on the safeguard, refer to the Installation and Design Precautions in the Safety
chapter of the EPSON RC+ User's Guide.
The following items are safety precautions for design personnel:
■ Personnel who design and/or construct the robot system with this product
must read the Safety chapter in the EPSON RC+ User's Guide to understand
the safety requirements before designing and/or constructing the robot
system. Designing and/or constructing the robot system without
understanding the safety requirements is extremely hazardous, and may
result in serious bodily injury and/or severe equipment damage to the robot
system.
■ The Manipulator and the Controller must be used within the environmental
conditions described in their respective manuals. This product has been
designed and manufactured strictly for use in a normal indoor environment.
WARNING
Using the product in an environment that exceeds the specified
environmental conditions may not only shorten the life cycle of the product
but may also cause serious safety problems.
■ The robot system must be used within the installation requirements described
in the manuals. Using the robot system outside of the installation
requirements may not only shorten the life cycle of the product but also
cause serious safety problems.
Further precautions for installation are mentioned in the following manuals.
Please read this chapter carefully to understand safe installation procedures before
installing the robots and robotic equipment.

1.2.1 Relevant Manuals

This manual
Refer
Manipulator manual : Setup & Operation 3. Environment and Installation

Controller manual
2
: 2. Installation
: Setup & Operation 3. Installation
Safety and Installation (RC90-B / EPSON RC+ 7.0) Rev.4
Trained