Table of Contents
Advertisement
7700 MultiFrame Manual
7710XUC-HD HD Format Up/Down/Cross Converter
6.3.
CONFIGURING THE VIDEO CONTROLS
The Video menus are used to configure parameters associated with the input and output video standards
and output video timing. The chart below shows the items available in the Video menu. Sections 6.3.1 to
6.3.14 provide detailed information about each of the menu items.
Video Frame Rate
Video Standard Input
Video Standard Output
Video Input Source
Pgm Out/In Mode
Pulldown Reference
A Frame Offset
SD Blanking
VITC Read Select
VITC Write Select
Time Code Source
Loss of Video
Force Minimum Delay
Reference Select
V Phase Offset
H Phase Offset
6.3.1. Setting the Video Input and Output Frame rate
Video
Frame Rate
59.94/29.97/23.98
50/25
7710XUC-HD
-18
Selects the video input and output frame rate
Selects the video input standard
Selects the video output standard
Selects video input from PGM IN or PGM OUT/IN BNC
Sets input or output mode of PGM OUT/IN BNC
Selects the 3:2 pulldown reference source
Sets the offset of the A Frame from the Pulldown Referenc
Selects upper lines as video or blank (525 input only)
Selects line for VITC reader (SD input formats only)
Selects line for VITC generator (SD output formats only)
Selects the source of Time Code.
Selects the action to take when the input video is missing
Set the H and V phase such that the path delay in minimized
Selects external or video locking reference
Sets the vertical phase of the output signal to the Genlock reference
input
Sets the horizontal phase of the output signal to the Genlock reference
input
This control selects the group of video standards that are available on the
Input Standard menu item. The card does not do temporal processing, so
converting from one frame rate to another is not possible.
Revision 1.0
Advertisement
Table of Contents
