Table of Contents
Advertisement
7700 MultiFrame Manual
7710XUC-HD HD Format Up/Down/Cross Converter
EVERTZ (C) A7710XDC
MODULE STATUS
SIGNAL PRESENT
Figure 13: Location of Jumpers – Sub Module for 7710XUDC-AES4-HD
7.1.
SELECTING WHETHER LOCAL FAULTS WILL BE MONITORED
BY THE GLOBAL FRAME STATUS
FRAME STATUS
The FRAME STATUS jumper J5 located at the front of the main module determines
whether local faults (as shown by the Local Fault indicator) will be connected to the
7700FR frame's global status bus.
To monitor faults on this module with the frame status indicators (on the PS FRAME
STATUS LEDs and on the Frame's Fault Tally output), install this jumper in the on
position (default).
When this jumper is installed in the off position, local faults on this module will not
be monitored.
7.2.
CONFIGURING THE MODULE FOR FIRMWARE UPGRADES
Firmware updates can be performed using the Upgrade menu item on the Utilities menu (see section
6.12.5) or using the UPGRADE jumper.
UPGRADE
The UPGRADE switch is located on the back of the main module (on the rear of the
J7 jumper location near the front card edge) and is used when firmware upgrades
are being done to the module. For normal operation, it should be switched to the
RUN position as shown in the diagrams above.
chapter in the front of the binder for more information.
The silkscreen on the front side of the board for J7 is incorrect.
orientation of the switch is shown in Figure 11 and Figure 12
7710XUC-HD
-50
SFF POWER
GND
+12V
Revision 1.0
SDI OUT/
J25
Composite
SDI OUT/
J26
Composite
+5V +12V
J19
GPI LEVEL
See the Upgrading Firmware
The correct
Advertisement
Table of Contents
