Table of Contents
Advertisement
7700 MultiFrame Manual
7721AE8-DEE-HD HD-SDI/SD-SDI Audio Embedder with Dolby Encoder
The parameter adjustments are REAL TIME ADJUSTMENTS and will affect the
output video/audio immediately. These settings should not be adjusted when the
output video/audio is in the broadcast chain.
6.3.
CONFIGURING THE VIDEO CONTROLS
The Video Control menus are used to configure parameters associated with the module's operating
standards, output video timing and loss of video mode. The chart below shows the items available in the
Video Control menus. Sections 6.3.1 to 6.3.5 provide detailed information about each of the menu items.
Video Standard
VSTD
Select
VDLY
Vertical Phase
HDLY
Horizontal Phase
FDLY
Frame Phase
LOVM
Freeze Mode
6.3.1. Setting the Video Standard
Video Control
VSTD
Auto detect
625i/50
525i/59.94
1080i/50
1080i/59.94
1080i/60
720p/59.94
720p/60
1080p/23.98sF
1080p/24sF
1035i/59.94
1035i/60
720p/50
This control is NOT a LIVE control.
pushbutton is pressed.
Page-14
Sets the video standard that the module will operate in.
Sets the vertical delay of the output video.
Sets horizontal delay of the output video.
Sets frame delay of the output video.
Sets module action when input video is lost.
Table 6-2: Video Controls Menu
This control selects the operating standard that the module will
operate in. The internal timing of the module will be based on this
standard. If the operating standard is set to Auto detect, then the
AUTO
module will operate based on the input video standard.
PALB
NTSC
If the operating standard is set to a specific value (e.g. 525i/59.94),
1I50
then regardless of the input video standard, the module will operate
1I59
in 525i/59.94.
1I60
7P59
The output video standard will always be the same as the operating
7P60
standard. However, NO format or standard conversion will occur.
1S23
1S24
3I59
3I60
7P50
Revision 1.2
The parameter will change once the
Advertisement
Table of Contents
