6.5.3. Setting the Motion Detection Controls
De-interlacer
Motion Detection
Threshold
4
0 to 15
6.5.4. Setting the Interfield Weighting Factor
De-interlacer
Interfield Weighting
Factor
40
0 to 255
6.6.
CONFIGURING THE VIDEO PROCESSING FUNCTIONS
The Proc Func menus are used to configure parameters associated with the video processing functions of
the converter. The chart below shows the items available in the Proc Func menu. Sections 6.6.1 to
6.6.12 give detailed information about each of the menu items.
simultaneous up-/cross-conversion and down-conversion, and has another set of identical menu items
(the Proc Func - DC menu items) for its down-converter. For the sake of brevity only the main Proc Func
menus will be described in this manual.
RGB Clip
Gamma Adjust
Y Gain
Y Offset
Cr Gain
Cr Offset
Cb Gain
Cb Offset
Hue
R Gain
G Gain
B Gain
Gamma Level
Luma Floor
Detail Noise Floor
Enhancement Limit
Horizontal Band
Vertical Intensity
Detail Gain
With this control, you can change the threshold of what is deemed motion
by the de-interlacer.
With this control, you can set the Interfield Weighting Factor control.
Enables RGB Clipping
Enables Gamma Adjust
Sets the Source Y Gain
Sets the Source Y Offset
Sets the Source Cr Gain
Sets the Source Cr Offset
Sets the Source Cb Gain
Sets the Source Cb Offset
+/- 10 degrees 0.1 degree steps
Sets the Gain in RGB Domain
Sets the Gain in RGB Domain
Sets the Gain in RGB Domain
Sets the gamma correction factor
Sets the darkest luma value that will be enhanced
Sets the minimum level of detail required before the enhancer is enabled
Sets the maximum enhancement allowed
Sets the horizontal frequency band
Sets the intensity of the vertical enhancement process
Sets the gain for detail
Revision 1.0
7710XUC-HD HD Format Up/Down/Cross Converter
The 7710XUDC-AES4-HD offers
7700 MultiFrame Manual
7710XUC-HD
-31