Table of Contents
Advertisement
6.3.
CONFIGURING THE VIDEO CONTROLS
The Video menus are used to configure parameters associated with the input and output video standards
and output video timing. The chart below shows the items available in the Video menu. Sections 6.3.1 to
6.3.10 give detailed information about each of the menu items.
Frame Rate
Video Input
Pulldown Reference
A Frame Offset
VITC Reader Line
VITC Generator Line
Time Code Source
Loss of Video
Force Minimum Delay
Reference Select
OSD / GLCK BNC
V Phase Offset
H Phase Offset
* - These functions are not yet implemented
6.3.1. Setting the Video Input and Output Frame rate
Video
Frame Rate
59.94/29.97/23.98
50/25
Select the video input frame rate
Selects the video input standard.
Selects the reference source when 3:2 pulldown is being added on the
output.
Sets the offset of the A Frame from the Pulldown Reference when 3:2
pulldown is being added on the output
Select line for VITC reader - SD input formats only (*)
Select line for VITC generator. (*)
Selects the source of Time Code. (*)
Selects the action to take when the input video is missing
Set the H and V phase such that the path delay in minimized
Selects internal or video and locking reference
Selects whether the BNC is used as an OSD output or genlock input
reference
Sets the vertical phase of the output signal relative to the genlock
reference input
Sets the horizontal phase of the output signal relative to the genlock
reference input
This control selects the group of frame rates that are available on the Input
Standard menu item.
converting from one frame rate to another is not possible.
Revision 1.1
7714HDC High Quality Down Converter
The card does not do temporal processing so
7700 MultiFrame Manual
7714HDC - 13
Advertisement
Table of Contents
