Table of Contents
Advertisement
7700 MultiFrame Manual
7772MFX-HD JPEG2000 SD & HD Encoder and Decoder
7.
DECODE CARD EDGE MENU SYSTEM
7.1.
TOP LEVEL DECODE MENU STRUCTURE
Table 7-1 provides a brief description of the top level menu tree that appears when the user enters the
card edge menu system. Selecting one of these items will take you to the next menu level, which enables
the user to set the value of that parameter. The details of the each of the menu items are described in
sections 7.2 to 7.7.
VCTR
Video Control
ACTR
Audio Control
Transport Stream
TSCO
Control
HEAD
Headphone Monitor
STAT
Status
MISC
Miscellaneous
7.2.
CONFIGURING THE VIDEO CONTROLS
The Video Control menus are used to configure parameters associated with the module's output video
timing. The chart below shows the items available in the Video Control menus. Sections 7.2.1 to 7.2.3
provide detailed information about each of the menu items.
VDLY
Vertical Phase
HDLY
Horizontal Phase
FDLY
Frame Phase
LOVM
Loss of Video Mode
7772MFX-HD - 22
Sets the video standard in which the module will operate, the timing
offset of the video output, the loss of video mode and VANC control.
Sets the audio controls for the module such as: Coarse and fine
audio delays; Sample Rate Converter mode; C-bit control;
Embedder Group enable; Demux loss of video mode; and Audio
output selection.
Controls the transport stream parameters, such as PID numbers,
TSID, etc.
Sets the headphone volume level and selects the source for
headphone monitoring.
Reports the status of the firmware, FPGA revisions, input/output
video standard.
Enables VistaLINK
reset.
Table 7-1: Top Level Menu Structure
Sets the vertical delay of the output video.
Sets horizontal delay of the output video.
Sets frame delay of the output video.
Sets the output status when the input is lost.
Table 7-2: Video Controls Menu
Revision 1.2
, sets display orientation, and performs factory
®
Advertisement
Table of Contents
