Configuring The Video And Source Id Controls; Controlling The Composite Analog Video Parameters; Setting The Ntsc Setup Pedestal - evertz 7700 Manual

7.5.

CONFIGURING THE VIDEO AND SOURCE ID CONTROLS

The Video/SID menus are used to configure parameters associated with the video input and output
functions and the Source ID decoders. The chart below shows the items available in the Video/SID menu.
Sections 7.5.1 to 7.5.7 provide detailed information about each of the parameters.
Analog Video
Video Standard
Loss of Video
525 VITC line
625 VITC line
525 PESA line
625 PESA line
525 H phase
625 H phase
H Delay
525 V phase
625 V phase
V Delay
525 Colour Frame
Offset
625 Colour Frame
Offset

7.5.1. Controlling the Composite Analog Video Parameters

7.5.1.1. Setting the NTSC Setup Pedestal

Video/SID
Analog Video
NTSC setup
pedestal
On
Off
7735AVC-LB Video Composite Encoder and Audio DAC with SoftSwitch
Controls the parameters such as NTSC setup pedestal, output level, hue,
saturation, contrast and brightness on the composite analog video output.
Selects the input video standard.
Selects the action to take when the input video is missing.
Sets the line number for decoding Vertical Interval Time Code in 525 line
video.
Sets the line number for decoding Vertical Interval Time Code in 625 line
video.
Sets the line number for decoding PESA format Source ID in 525 line video.
Sets the line number for decoding PESA format Source ID in 625 line video.
Sets the horizontal phase of the output signal to the NTSC Genlock reference
input.
Sets the horizontal phase of the output signal to the PAL Genlock reference
input.
Status display which shows the current horizontal input to output delay.
Sets the vertical phase of the output signal to the NTSC Genlock reference
input.
Sets the vertical phase of the output signal to the PAL Genlock reference
input.
Status display which shows the current vertical input to output delay.
Sets the offset in frames between colour frame 1 of the NTSC output signal
with respect to colour frame 1 of the NTSC Genlock reference input.
Sets the offset in frames between colour frame 1 of the PAL output signal
with respect to colour frame 1 of the PAL Genlock reference input.
The NTSC setup pedestal should not be present when operating in Japan.
This control allows it to be removed.
When the NTSC setup is On, the Line 21 Setup control determines whether
setup will be applied to line 21.
Revision 1.6
7700 MultiFrame Manual
7735AVC-LB - 19