6.3.
CONFIGURING THE VIDEO CONTROLS
The Video menus are used to configure parameters associated with the input and output video standards
and output video timing. The chart below shows the items available in the Video menu. Sections 6.3.3.1
to 6.3.3.3 give detailed information about each of the menu items.
Line 21 CC
Reference Select
1080i/59.94 V Phase
Offset
1080i/59.94 H Phase
Offset
1080i/50 V Phase
Offset
1080i/50 H Phase
Offset
720p/59.94 V Phase
Offset
720p/59.94 H Phase
Offset
720p/50 V Phase
Offset
720p/50 H Phase
Offset
6.3.1. Blanking Line 21 Captions
Video
Line 21 CC Blanking
Blank
Pass
6.3.2. Reference Select
Video
Reference Select
external
video
6.3.3. Setting up the Video Output Timing
The output stage of the upconverter contains a frame buffer and a line buffer so that the output video can
be timed with respect to the reference applied to the GENLOCK input loop. In the absence of a genlock
signal the output video will be timed with respect to the incoming SD Video.
Determines if line 21 will be blanked prior to upconversion
Sets the source of the genlock reference input
Sets the vertical phase of the output signal to the genlock reference input
- 1080i/59.94 output video
Sets the horizontal phase of the output signal to the genlock reference input
- 1080i/59.94 output video
Sets the vertical phase of the output signal to the genlock reference input
- 1080i/50 output video
Sets the horizontal phase of the output signal to the genlock reference input
- 1080i/50 output video
Sets the vertical phase of the output signal to the genlock reference input
- 720p/59.94 output video
Sets the horizontal phase of the output signal to the genlock reference input
- 720p/59.94 output video
Sets the vertical phase of the output signal to the genlock reference input
- 720p/50 output video
Sets the horizontal phase of the output signal to the genlock reference input
- 720p/50 output video
With this control, you can blank line 21 (where closed caption information
may be present) prior to upconverting the signal.
With this control, you can select the genlock reference to be from an
external source or the video signal.
Revision 1.3
7700 MultiFrame Manual
7710UC-HD HD UpConverter
7710UC-HD-11