Adding The Ntsc Setup Pedestal; Colour Bars; Setting The Composite Display Mode - Colour Or Monochrome - evertz 7700 Manual

NTSC setup
pedestal

Colour Bars

Composite display
mode
Video level
Hue
H blanking
VBI processing
Y Filter Selection
Wideband Freq
Chroma Filter

6.11.1. Adding the NTSC Setup Pedestal

Composite Output
NTSC setup
pedestal
Off
On
6.11.2. Colour Bars
Composite Output
Colour bars
On,
Off
6.11.3. Setting the Composite Display Mode – Colour or Monochrome
Composite Output
Composite
display mode
Colour
B/W
Selects whether the NTSC 7.5 IRE pedestal will be added to the composite
analog output video
Turns on internally generated colour bar test signal
Selection of colour or B/W modes
Controls the output video level
Controls the output video hue
Controls the width of horizontal blanking
Either passes or blanks the vertical blanking interval lines
Selects either standard composite filtering or adjustable filtering is selectable
Controls the frequency response with the wideband filter selected
Various chroma bandwidths are available with this control
Composite NTSC analog video may have a 7.5 IRE pedestal while 4:2:2 SDI
video does not. This control, when set to On, will add the pedestal and re-scale
the video accordingly.
Note: The setup pedestal should not be present on composite video
when operating in Japan.
This control enables and disables an internally generated colour bars signal to
aid in video level calibration.
If monochrome operation is desired on the composite output, colour may be
turned off with this control.
7710XUC-HD HD Format Up/Down/Cross Converter
Revision 1.0
7700 MultiFrame Manual
7710XUC-HD
-43