7700 MultiFrame Manual
7700SID(-AM) Source Identification Decoder
5.6.
VIDEO AND SID CONTROLS
5.6.1. Video Standard/Mode
VIDEO/SID
VIDEO
STANDARD
525
625
AUTO
5.6.2. SDI Output Keyer
WINDOWS
SDI OUTPUT
KEYER
TEXT,
TEXT +
AUDIO
5.6.3. The 7760AVM Does not have both of these on/off controls! Only one output. Composite
Output Keyer
WINDOWS
COMPOSITE
OUTPUT
KEYER
TEXT,
TEXT +
AUDIO
5.6.4. NTSC Setup Pedestal
VIDEO/SID
NTSC SETUP
PEDESTAL
ON, OFF
7700SID(-AM)-14
Select the video standard or auto mode.
The video line standards is selected with this control. If set to AUTO
mode, the card will adjust operation as needed for the incoming standard.
This menu item is not controllable if the DIP switches have been enabled
in the "DIP SWITCHES" menu. It will however, report the current state of
the control set by the DIP switches. Auto mode is not available if the DIP
switches are enabled.
On/off control of text and audio bar graph information on the SDI output.
The information on the SDI output can be configured with this control.
Either text or text and audio bar graphs may displayed on the SDI output.
On/off control of text and audio bar graph information on the composite
output.
The information on the composite output can be configured with this
control. Either text or text and audio bar graphs may displayed on the SDI
output.
Turn the 7.5 IRE pedestal on or off when operating in 525.
The setup pedestal should not be present when operating in Japan. This
control allows it to be removed.
Revision 0.3