Table of Contents
Advertisement
7700 MultiFrame Manual
7710XUC-HD HD Format Up/Down/Cross Converter
SUBMODULE
toggle
switch
Four large LEDS on the front of the main board indicate the general health of the module:
LOCAL FAULT:
This red LED indicates poor module health and will be on during the absence of a
valid input signal or if a local input power fault exists (i.e.: a blown fuse). The red
LED will also turn on if there is no valid video signal present at the module input or if
the board is not locked to the genlock source. The LOCAL FAULT indication can
also be reported to the frame through the FRAME STATUS jumper.
MODULE OK:
This green LED indicates good module health. It will be on when a valid input signal
is present, the board is locked to the genlock source, and the board power is good.
VIDEO PRESENT
This green LED will be on when there is a valid video signal present at the module
input, depending on the module configuration.
source is Main PGM, then the LED will indicate a signal presence on that input. The
same applies if PGM IN/OUT is configured as the video input source.
GENLOCK
This green LED will be on when there is a signal present at the module Genlock
input. This LED will blink to indicate that an improper signal for the current video
format is present.
The large LEDs on the sub board of the module (only on "-AES4" versions) indicate the following:
SUBMODULE OK:
This green LED indicates good module health. On the 7710XUDC-AES4-HD, it will
be on when a valid input signal is present on the sub board, and the board power is
good. On the 7710XUC-AES4-HD, it is identical to the MODULE OK LED on the
main board.
VIDEO LOCKED
This green LED will be on when there is a down-converted video signal on the sub
board.
7710XUC-HD
-12
VIDEO
OK
LOCKED
OK
MODULE
OK
VIDEO
push
PRESENT
button
LOCAL
GENLOCK
FAULT
Figure 7: LED Status Indicators: "-AES4" Versions
1 2 3 4 5 6 7 8
1
2
AES Inputs
1
2
3
Audio Group
Revision 1.0
3
4
7710XUDC-AES4-HD
4
For example, if the video input
Advertisement
Table of Contents
