Table of Contents
Advertisement
media item allows it to be viewed on the preview output buss before it is faded in. If the LED
is illuminated, the media item has been cued.
Cued animations are loaded into memory and paused on the first frame of the animation
until the Fade In command is received.
vertically on the preview output. Gain level setting changes are visible on the preview
output channels; therefore all Cued logos are keyed at 100%. Cued logos will repeat their
fade in, hold and fade out sequence over and over again on the preview output. On Media
Keyer units, audio clips will play over and over again. If you cue a playlist item on a Media
Keyer, the logo and its associated audio clip will both be cued. This allows you to preview
the entire logo and audio clip quickly and easily before placing it on air.
IN
This button is used to fade in the currently selected media item onto the Program output
channels. Logos are keyed on the program output at their Gain level settings. If the media
item has not been previously cued, it must be loaded into memory before it can be faded in.
This process may take a few seconds while the item is being cued. If the media item is not
currently loaded into memory, a progress indicator will appear to the right of the logo name
while it is loading into memory. If you fade in a playlist item on a Media Keyer, the logo and
its associated audio clip will both be faded in. If the LED is illuminated, the media item has
been faded in. The media item name will flash on the front panel display indicating that it is
faded in.
OUT
This button is used to fade out the currently selected media item from the Program output
channels. If you fade out a playlist item on a Media Keyer, the logo and its associated audio
clip will both be faded out. If the LED is illuminated, the media item has been faded out. The
media item name will stop flashing on the front panel display indicating that it is faded out.
ALL OUT
This button is used to fade out all media items from the Program output channels. If the
LED is illuminated, all media items have been faded out.
SELECT When you are not in the Setup Menu, this button controls whether the selected media item
shown on the front panel display is present on the Program output buss. Scroll to the logo
required using the SHAFT ENCODER
in its name will flash in the front panel display and the IN LED will be ON. To fade the media
item in, press the SELECT button. The media item will fade in according to its programmed
fade in time and the media item name display will begin flashing. If the media item is not
currently loaded into the memory, a progress indicator will appear to the right of the logo
name while it is loading into memory. To remove a media item from the output video
busses, press the SELECT button when the media item name is flashing. The media item
will fade out according to its programmed fade out time and its name display will stop
flashing.
4.1.2. The Quick Select Button Group
QUICK SELECT
These buttons are used as a quick method to fade in and out frequently used
media items. On the Logo Inserters you can access up to 10 logos using the quick select
keys. On the Media Keyers you can access up to 8 media items. Each button can access
two different media items depending on the state of the SHIFT LOCK LED. When the
SHIFT LOCK LED is Off the QUICK SELECT buttons access the lower numbered Quick
Select. When the SHIFT LOCK LED is On, the QUICK SELECT buttons access the high
numbered Quick Select items.
DESKTOP CONTROL PANEL
9625LG Series Logo Inserters and Media Keyers Manual
Cued logos may be moved horizontally and
&
buttons. If the media item is currently faded
Revision 4.2
Page 4-3
Advertisement
Table of Contents
