Table of Contents
Advertisement
9625LG Series Logo Inserters and Media Keyers Manual
3.1.7. Front Panel Display Functions
The 16 character alphanumeric display is used to show the name of the logo that will be cued, faded in
or out by pressing the CUE, SELECT, IN or OUT buttons. The display is also used to show the Setup
menu items to configure the 9625LG Series Keyer unit.
3.2.
OVERVIEW OF FRONT PANEL OPERATION
Scroll to the media item required using the
name will flash in the front panel display. To load a media item into memory and display it on the
preview buss, press the CUE button. To fade in a media item on the program buss, press the SELECT
or IN button. The media item will fade in according to its programmed fade in time, the IN LED will be
On and the media item name display will begin flashing. If the media item is not currently loaded into
memory, a progress indicator will appear to the right of the media item name while it is loading into
memory. To fade out a media item from the output buss, press the SELECT or OUT button when the
logo name is flashing. The media item will fade out according to its programmed fade out time. The
OUT LED will be On and the media item name display will stop flashing. To remove all media items
from the output video buss, press the ALL OUT button.
3.3.
AN OVERVIEW OF THE SETUP MENU SYSTEM
The SETUP menu system uses the 16 digit alphanumeric display and provides a quick, intuitive method
of configuring the 9625LG Series Keyer. These items are often only required to be set up at installation
time, and do not pertain to the day-to-day operation of the unit. Figure 3-5 provides an overview of the
Setup menu system.
3.4.
NAVIGATING THE SETUP MENU
To enter the Setup menu, press the SETUP button. This will bring you to the main Setup menu where
you can use the
&
items are shown in UPPERCASE. Once you have chosen the desired sub-menu, press the SELECT
button to select the next menu level.
Once in a sub-menu, there may be another menu layer (shown in Title Case), or there may be a list of
parameters to adjust (shown in lower case). If there is another set of menu choices, use the
buttons to select the desired menu item and press the SELECT button. Continue this process until you
get to the bottom of the menu tree where the list of parameters to be adjusted is shown.
To adjust any parameter, use the
parameter. To view the possible values for that item, press the SELECT button. The current value for
that parameter will be shown with an asterisk (*). Pressing the
possible values for the selected parameter.
selected will NOT have an asterisk (*). When you have stopped at the desired value, press the
SELECT button to save your selection. The value will be shown with an asterisk (*), indicating that it is
now the current value. To move up one level in the menu press the SETUP button.
You can select other parameters from that submenu by using the
SELECT button. Alternately you can move up one menu item by pressing the SETUP button.
Page 3-6
&
buttons to move up and down the list of available sub-menus. Top level menu
&
buttons to move up or down the parameter list to the desired
buttons. If the media item is currently faded in its
&
The various parameter values that are not currently
Revision 4.2
buttons allows you to show the
&
buttons, followed by the
OPERATION
&
Advertisement
Table of Contents
