Table of Contents
Advertisement
12) Press Enter
Your Sage is now configured to work with the 9625LG Series Keyer. Proceed to section 5.1.4 to
connect the audio and GPI controls, to configure the 9625LG Series Keyer and verify that the
connections are functioning as expected.
5.1.3. TFT Decoder Configuration
The TFT unit has a number of communications ports on the rear of the unit marked as COM 1 to COM
3 and J103 and J104. The baud rate is fixed at 9600 within the 9625LG Series Keyer and it is
configured to communicate using the Alternate TFT I/F for Trilithic EAS Sytems ALT1 option. This
means you must plug the female end of the straight-through RS232 cable into the COM 2 port of the
TFT decoder and configure the port accordingly. The serial port is wired like a standard PC 9-pin
connector. This will require that your TFT unit be equipped with the Four Port Expander Board option.
If your unit is not so equipped, please contact TFT and order this field installable option.
The TFT port must be configured to output the type of data that the 9625LG Series Keyer unit is
expecting. To do this, follow these steps on the TFT unit.
1) Press Password
2) Enter Primary Password
3) Press Password
4) Enter Setup Password
5) Scroll down to item 18 Enable Character Generator Interface
6) Press Enter
7) Scroll down to Alt1 Alternate TFT I/F for Trilithic EAS Systems
8) Press Enter
9) Scroll down to item 27 Enable CG Text for RWT
10) Press Enter
11) Scroll up or down to Yes
12) Press Enter
13) Press Exit
Your TFT unit is now configured to work with the 9625LG Series Keyer. Proceed to section 5.1.4 to
connect the audio and GPI controls, to configure the 9625LG Series Keyer and verify that the
connections are functioning as expected.
5.1.4. Connecting the Audio
The emergency audio from the Sage or TFT decoders must be converted to an AES audio stream
before it can be used with the 9625LG Series Keyer. You can use the Evertz 7720ADC-A4 Analog
Audio to AES Converter module, or other suitable device to do this. Connect the AES1 output from the
7720ADC-A4 into the AES ALT input on the 9625LG Series Keyer, which has been specified as the
voiceover input via the HTML Audio Setup page. (See section 3.11.1)
EAS
9625LG Series Logo Inserters and Media Keyers Manual
Revision 4.2
Page 5-3
Advertisement
Table of Contents
