Table of Contents
Advertisement
4.1.5. Setup Button Group
SETUP
This button is used to enter the Setup menu, which is used to configure the operating modes
of the keyer. (See section 3.3 for an overview of the Setup menu.) When you are in the
Setup menu, this button is also used to back out of menu selections to the next higher menu
level or to exit the Setup menu and return to normal panel operation.
SELECT When in the Setup menu, this button is used to choose a submenu and navigate to the next
level down in the menu structure. When you are at the bottom level of the menu system it is
also used to accept numeric values or to make the displayed menu choice the active value
for that menu item.
When you are not in the Setup menu, this button is also used to fade logos in and out on the
selected output buss.
4.1.6. Control Panel Status Indicators
The illuminated buttons show operational status of the 9625LG Series Keyer at a glance. When they
are On they indicate that the function associated with the button is active.
LOGO, KEYER
indicates that at least one media item is faded in and available on the Program output buss.
COMM
This LED is used to signal two types of communication to the 9625LG Series Keyer. When
it is flashing On approximately every 1.5 seconds, it is indicating that the control panel is
communicating with the main microprocessor in the unit. When the 9625LG Series Keyer is
under automation control, or logos or other media files are being transferred to or from the
unit using the Nomad™ or Overture™ software, the LED will be on when the unit is
receiving data from the control source.
If it is Off continuously, that means that the control panel has lost communications with the
main unit. In that case check the cabling if you are using a remote control panel. Otherwise
the unit may require a reboot if the buttons on the control panel are not responding.
4.2.
OVERVIEW OF DESKTOP CONTROL PANEL OPERATION
4.2.1. Displaying Logos
Scroll to the media item required using the SHAFT ENCODER. If the media item is currently faded in
its name will flash in the front panel display. To load a media item into memory and display it on the
preview buss, press the CUE button. To fade in a media item on the program buss, press the SELECT
or FADE IN button. The media item will fade in according to its programmed fade in time and the
media item name display will begin flashing. If the media item is not currently loaded into memory, a
progress indicator will appear to the right of the media item name while it is loading into memory. To
fade out a media item from the output buss, press the SELECT or FADE OUT button when the logo
name is flashing. The logo will fade out according to its programmed fade out time and the logo name
display will stop flashing. To remove all media items from the output video buss, press the ALL OUT
button.
DESKTOP CONTROL PANEL
9625LG Series Logo Inserters and Media Keyers Manual
This LED (labelled LOGO on Logo Inserters and KEYER on Media Keyers)
Revision 4.2
Page 4-5
Advertisement
Table of Contents
