Table of Contents
Advertisement
6.4.
SERVICING INSTRUCTIONS
CAUTION – These servicing instructions are for use by qualified service
personnel only.
servicing instructions in this section of the manual unless you are qualified
to do so.
6.4.1. Changing The Fuses
Check that the line fuse is rated for the correct value marked on the rear
panel. Never replace with a fuse of greater value.
The fuse holder is located inside the power entry module. To change the fuses, pull out the fuse
holder from the power entry module using a small screwdriver. The fuse holder contains two fuses,
one for the line and one for the neutral side of the mains connection. Pull out the blown fuse and
place a fuse of the correct value in its place. Use time delay 5 x 20 mm fuses rated for 250 Volts with
a current rating of 1 amp. Carefully reinsert the fuse holder into the power entry module.
TECHNICAL DESCRIPTION
9625LG Series Logo Inserters and Media Keyers Manual
To reduce risk of electric shock do not perform any
Revision 4.2
Page 6-7
Advertisement
Table of Contents
