Table of Contents
Advertisement
9625LG Series Logo Inserters and Media Keyers Manual
3.10.1. Setting the Logo Horizontal Position
MEDIA
H
H : 0
0 to max pixels
3.10.2. Setting the Logo Vertical Position
MEDIA
V
V : 0
0 to max lines
3.10.3. Setting the Logo Transparency
MEDIA
Gain
Gain: 100%
3.10.4. Setting the Logo Fade In Duration
MEDIA
Fade In
Fade in:30
Page 3-28
This menu item is used to set the horizontal position for the current logo.
The position is referenced to the left edge of the logo. The range of values
depends on video standard in use.
Use the
or
buttons to adjust the position. The logo will move on the
screen as you adjust its position.
This menu item is used to set the vertical position for the current logo. The
position is referenced to the top edge of the logo. The range of values
depends on video standard in use.
Use the
or
buttons to adjust the position. The logo will move on the
screen as you adjust its position.
This menu item is used to adjust the opacity (the inverse of transparency)
of the logo as a percentage of the original opacity when the logo was
created. When the Logo Gain is set at its default value of 100 the logo will
be displayed at its original opacity.
For example, if the logo is created at 10% opaque, adjusting the Gain value
to 200 will render the logo as 20% opaque. If the logo is created at 50%
opaque, adjusting the Gain value to 200 will render the logo as 100%
opaque. Gain values resulting in opacity levels above 100% are ignored.
Use the
or
buttons to adjust the Gain and then press the SELECT
button to make the change.
This menu item is used to set the fade in rate for the current logo. The
range of values is 1 to 600 frames. The Fade In menu item only applies to
static and crawl logos.
Use the
or
buttons to adjust the Fade In time and then press the
SELECT button to make the change.
Revision 4.2
OPERATION
Advertisement
Table of Contents
