Table of Contents
Advertisement
3.6.7. Setting the Output Mode
GENERAL
Output Mode
Pvw/Pgm
Pvw/Key/Fill
3.6.8. Viewing and Updating the Firmware Version
GENERAL
Update Code
1.01 build 100
boot 1.01
yes - upgrade now
3.6.9. Configuring the Up/Down Timers
The 9625LG Series Keyers have the ability to insert a logo, which displays a count down or count up
timer. The Up Down Timer menu is used to configure the timers that are used for this purpose. The
following is a description of each of the sub-menus.
OPERATION
9625LG Series Logo Inserters and Media Keyers Manual
This menu item allows you to choose the output video style for the logo
insertion.
Select Pvw/Pgm if you are using your logo inserter as a standard on-air
device. In this mode the logo is keyed over the input video according to the
associated key information and is available on the PREV OUT BNC and
the PROG OUT BNCs.
Select Pvw/Key/Fill if you have a switcher or a downstream keyer that
requires a separate key and fill signal. In this mode the logo is keyed over
the input video according to the associated key information and is available
on the PREV OUT BNC. Program Output BNCs will contain the Logo fill
data on the FILL BNC and the Logo key data on the KEY BNC. In this
mode you must supply a valid video timing reference signal to the unit.
You can provide either an analog video signal into the REF input BNC or a
serial digital video signal to the INPUT BNC. The input signal must be
running the same video standard as required by your downstream switcher
or keyer. See section 3.6.2 for information on selecting the video timing
reference signal.
The Firmware menu item allows you to view the firmware version that is
installed in the 9625LG Series Keyer. It also enables you to update the
firmware.
When you press the SELECT button, the display shows the software
version which will look similar to the following:
1.0 build 100
Use the
or
buttons to display the boot code version which will look
similar to the following:
Boot 1.01
Select yes - upgrade now to upgrade the firmware in the 9625LG Series
Keyer. For information on completing the firmware upgrade see section 6.2.
Revision 4.2
Page 3-17
Advertisement
Table of Contents
